Описание
Coolers condensate OG-6 are used for cooling the steam condensate heaters PN (low pressure) and PSV heaters (mains water) heating systems connected to CHP plants and industrial boilers. Heat which is released during the cooling of the steam condensate is used to heat more cold main condensate in the regeneration system of the turbine, saving heat in a cycle.
Note that the PC Boiler has the ability to produce modernized steam-water heaters with built-in cooler condensate!
The principle of operation and arrangement of chiller condensate OG-6
Chiller condensing type EXHAUST is a heat exchanger "water-water" the horizontal type, which consists of 1 section that uses countercurrent movement of the liquids. The cooler section of the condensate consists of a body of the pipe system and removable front and rear cameras or caps. The body of the cooler condensate OG-6 consists of two steel tube sheets with Cavalcanti they straight tubes 22х2. The front plate is tightly welded to the housing and is stationary and the rear movable seal parasitemie pads and flexible brass ring. Front and rear water chambers cooler OG-6 is made of welded steel in the form of a conical adapter flange du100/du200.
Overall dimensions of the drain cooler OG-6
Diameter, mm: 273
Length, mm.: 2328
The number of tubes, PCs: 56
The size of the tubes, mm: 22х2х1586 ST20
Характеристики
Характеристика | Значение |
---|---|
Площадь поверхности теплообмена, м2 | 6 |
Давление в корпуса, МПа | 0,39 |
Давление в трубной системе, МПа | 0,39 |
Температура на входе в корпусе, С | 115 |
Температура на входе в трубной системе, С | 100 |
Номинальный расход воды в корпусе, т/ч | 10 |
Номинальный расход воды в трубной системе, т/ч | 98 |
Количество ходов воды в корпусе, шт. | 2 |
Количество ходов воды в трубной системе, шт. | 1 |
Масса, кг. | 380 |
Comments ()